Machinability analysis of delamination and thrust force in drilling of pure and added GFRP composites
Küçük Resim Yok
Tarih
2022
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
SAGE Publications
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
The effects of cutting parameters on the thrust force and delamination factor in the drilling of pure, Al2O3, and SiO2 added GFRP/epoxy composites were investigated. Experimental studies were performed to investigate thrust force and delamination factor. Taguchi experimental design and response surface methodology were employed to establish parametric relationships between the experimental parameters and the machinability outputs consisting of delamination and thrust force. When examining the effect of cutting speed and feed on thrust forces and delamination factors for the three materials, the smallest values of the cutting parameters for all three materials gave the minimum thrust forces and delamination factors. Machinability Index is also proposed. According to the machinability index, under the effect of delamination and thrust force parameters, it was seen that pure epoxy composite material has better machinability than the other composite materials. It has been found that the effect of feed rate on delamination is greater than the cutting speed, and the cutting speed has a low effect.
Açıklama
Anahtar Kelimeler
delamination; GFRP; machining; thrust force
Kaynak
Journal of Composite Materials
WoS Q Değeri
Q3
Scopus Q Değeri
N/A
